Fernox
Power Flushing
The Problem
As soon as a heating system is completed and filled with water,
gradual corrosion and deterioration of the system begins. The
combination of water, air, a mixture of metals, and even installation
debris and contaminants, can result in internal corrosion, sludge
formation in areas of low flow, and scaling of boilers and heat
exchangers. The end result is symptoms such as those listed
below.
These problems are not inevitable, and good care and maintenance
of a heating system will prevent and often cure them.
Is your
heating system showing signs of old age?
Does it take ages to heat up?
Are some radiators completely or partially cold?
Do radiators need frequent bleeding?
Strange and unpleasant noises come the boiler?
Repeated pump failures?
Any of these symptoms could indicate that the system has circulation
and flow problems as a result of internal corrosion, scale and
sludge formation
We offer
a controlled chemical cleaning service for most domestic wet
central heating systems*. A professional service that can chemically
treat and flush clean deposits from your system, with minimal
disturbance and disruption to the normal operation of the system,
often without disconnecting the boiler or any radiators.
The
powerful flow, combined with an instantaneous flow reverser
device, will dislodge and mobilize deposits and corrosion which
resist traditional system cleaning methods.
Once
sludge and deposits are loosened and mobilized, they are power-flushed
out through a dump valve to waste, whilst fresh clean water
is forced through the system to replace the contaminated water.
At the
end of the flushing process, the system is full of water, and
re-instatement of the system to normal operation takes only
a short while.
*subject
to survey
For
further information and advice or to book a Furnox Power flush
please contact us.
|