Settings
Programmer (roomstat)
The digistat 2RF is a programmable thermostat that allows you to set up to 6 temperature changes per day. This auto mode is preset, but you may wish to change it. The other modes you need to know about are manual, and override.
Auto |
||
 |
 |
 |
With the roomstat set to auto, press  twice until the time on the display flashes. Use + or - to adjust the first time. |
Press to confirm the new time and use + or - to adjust the flashing temperature. The small number (in this case number 1) shows which time period is being set. |
Press to confirm the new temperature and repeat the procedure for the next time period, there are 6 time periods in total that can be adjusted. |
 |
||
To exit press  or until you return to the auto mode, with  pointing to auto (as shown). |
||
Override |
||
 |
 |
 |
| Press + or - to adjust the display to the desired temperature, which will flash. The display indicates override mode. |
After 5 seconds the display will revert to the current room temperature. The flame symbol  shows that the unit is calling for heat. |
To exit override, press once, or wait until the next time period when it will revert to auto automatically. |
Manual |
||
 |
 |
 |
| Press once, and the temperature display will flash. |
Press + or - to adjust the display to the desired temperature. After 5 seconds the display reverts to the current temperature. | The flame symbol shows that the unit is calling for heat. To exit manual mode, press once to return to auto. |